Chapter 7. Removing and replacing a FRU
External CRU statement to customers:
Some problems with your product can be resolved with a replacement part you can install yourself, called a “Customer Replaceable Unit” or “CRU.” Some CRUs are designated as
This chapter presents directions and drawings for use in removing and replacing a FRU. Be sure to observe the following general rules:
1.Do not try to service any tablet unless you have been trained and certified. An untrained person runs the risk of damaging parts.
2.Before replacing any FRU, review Chapter 6 “FRU replacement notices” on page 33.
3.Begin by removing any FRUs that have to be removed before replacing the failing FRU. Any such FRUs are listed at the top of each FRU replacement page. Remove them in the order in which they are listed.
4.Follow the correct sequence in the steps for removing a FRU, as given in the drawings by the numbers in square callouts.
5.When turning a screw to replace a FRU, turn it in the direction as given by the arrow in the drawing.
6.When removing a FRU, move it in the direction as given by the arrow in the drawing.
7.To put the new FRU in place, reverse the removal procedure and follow any notes that pertain to replacement. For information about connecting and arranging internal cables, see Chapter 8 “Locating the controls and hardware components” on page 49.
8.When replacing a FRU, use the correct screw(s) as shown in the procedures.
DANGER
Before removing any FRU, turn off the tablet, disconnect all power supplies, remove the internal battery, and then disconnect any interconnecting cable.
Attention: After replacing a FRU, do not turn on the tablet until you have made sure that all screws, springs, and other small parts are in place and none are loose inside the tablet. Verify this by shaking the tablet gently and listening for rattling sounds. Metallic parts or metal flakes can cause electrical short circuits.
Attention: The system board is sensitive to, and can be damaged by, electrostatic discharge. Before touching it, establish personal grounding by touching a ground point with one hand or by using an electrostatic discharge (ESD) strap (P/N 6405959).
Before servicing the ThinkPad Tablet
Some models of the ThinkPad Tablet you are servicing might have the SIM card that the customer has installed.
If the tablet you are servicing has the SIM card, remove it before you start the servicing.
© Copyright Lenovo 2011 | 35 |