Zebra Technologies 2742, 2722, 3742 user manual Dump Mode Printout

Page 27

Printer The printer has flash (non-volatile) memory to Configuration store printer configuration settings. The settings Settings are stored in flash memory and are set by programing, printer drivers or the AutoSense routine. The settings are shown on the Dump mode printout or can be reported back to the

host via the serial port.

The following are the basic settings stored in the printer:

Print Mode - Direct (OD) or Thermal Transfer (O)

Speed (S)

Density (D) or heat applied

Form (label) length and gap in dots (Q)

Form (label) width in dots (q)

Serial Port (Y)

Margin (R)

Buffer Mode (r)

Options: D

Print Mode is Direct Thermal (OD)

Dump Mode

Printout

(See the U command in the Programmer’s manual for details)

980344-001 Rev.A

23

Image 27

Contents Desktop Thermal Printer User’s Manual 2722 2742 Copyright Notice Table of Contents General Cautions and Warnings Installation and Operation Unpacking Your Printer Getting To Know Your Printer Step Attach Power Power OFFPlug Into Power Module Parallel Interface Serial Interface Step Attach Interface CableOpen Guides Step Load MediaOpen Cover Open Print HeadTag Stock Labels2742 Install Roll Media Install RollSeat Media Roll Thread the MediaClose Guides Close Cover Close Print HeadPress Feed Button Power onPrint Status Step Install SoftwarePress & Hold Feed Button Power on Step AutoSensePlace Media In Rear Face Print Surface UP Insert & Load Using Fan-Fold MediaPull Print Head Release Lever Movie Expose 15CM of LabelsPeel Cut End Exposed LinerLabel Dispense Option Insert LinerPull Liner Through Remove Presented Label Close Print Head Close CoverThermal Transfer Print Head Mechanism Ribbon Path Thermal Transfer Ribbon LoadingRear View Thermal Transfer Ribbon Loading Open Print HeadLoad Ribbon Core Start RibbonInstallation and Operation RED Appendix a TroubleshootingClean the Print Head Printer MaintenanceDump Mode Printout Wiring Interface 980344-001 Rev.A