Zebra Technologies 3742, 2742, 2722 user manual Labels, Tag Stock

Page 11

Installation and Operation

Before You Load You must remove the outside length of media Media in the (that is, one, full revolution of labels and any Printer liner). When you remove this part of the media, you remove the oils, dust, and adhesives that contaminate it. Tape or adhesive holds the loose end and the outside length of media becomes contaminated when handled or

stored.

Labels

Remove all labels that are held by adhesives or tape

MOVIE

Tag Stock

Detach both ends of the bottom tag

You must avoid dragging adhesive or dirty media between the print head and platen. Such an occurrence damages the print head and is not covered under your warranty. Using clean media prevents damage and reduces wear on the print head and platen.

980344-001 Rev.A

7

Image 11

Contents Desktop Thermal Printer User’s Manual 2722 2742 Copyright Notice Table of Contents General Cautions and Warnings Installation and Operation Unpacking Your Printer Getting To Know Your Printer Plug Into Power Module Step Attach PowerPower OFF Parallel Interface Serial Interface Step Attach Interface CableOpen Guides Step Load MediaOpen Cover Open Print HeadTag Stock Labels2742 Install Roll Media Install RollSeat Media Roll Thread the MediaClose Guides Close Cover Close Print HeadPress Feed Button Power onPrint Status Step Install SoftwarePress & Hold Feed Button Power on Step AutoSensePlace Media In Rear Face Print Surface UP Insert & Load Using Fan-Fold MediaPull Print Head Release Lever Movie Expose 15CM of LabelsPeel Cut End Exposed LinerPull Liner Through Label Dispense OptionInsert Liner Remove Presented Label Close Print Head Close CoverThermal Transfer Print Head Mechanism Ribbon Path Thermal Transfer Ribbon LoadingRear View Thermal Transfer Ribbon Loading Open Print HeadLoad Ribbon Core Start RibbonInstallation and Operation RED Appendix a TroubleshootingClean the Print Head Printer MaintenanceDump Mode Printout Wiring Interface 980344-001 Rev.A