Operating | Zebra Technologies A100 guide

us s: select Run from the Start enu.)

5. Type A:\SETUP (or B:\ ETUP) and then press OK. Operating6. Follow he on-screentheinstructionsSystemto complete the installation.

c eate a lab l for the A100 printer, you will need to design the label in a Windows ap li ation (such as BAR-ONE) and use that application’s print setup select the Zebra A100 printer before you print. Alternatively, you may use he Windows Printers Control Panel to select the Zebra A100 as

y ur	fault	rint	for all y ur Windows applications. The Zebra A100
print	d iver	rks like any oth r printer driver: by selecting the Zebra
A100 p inter		Pri	Setup or in the Windows Printers Control Panel you can
Tarprintrinterf om most Wind wsModesapplications to this printer.
	Operating
			The operator tears off each label (or a strip of labels) as
iteelis -intOffModed			.
			The backing material is peeled away from the label as it
is rinted, the printer waits until the operator removes the label, then the next
lab l is printed. .
Operator Controls
Power Switch			Located on the right-hand side of the printer near the

"back. The power switch should be turned off before connecting or discon- Feedn ctingKeyany.cables.

In normal use, pressing the Feed Key once when the printer is idle (not printing) will cause the printer to feed a blank label. Holding the Feed Key while turning the power on and for 2 seconds afterward causes a test pattern to print. See Figure 4. This test pattern allows your to quickly confirm that the printer is working without connecting it to a computer.