97882 Instructions.quark 2/26/02 1:32 PM Page 3
CONNECTING YOUR MOUSE
•If your computer has a USB port, it is recommended you use the USB con- nector on your mouse for the best and simplest connection.
•If your computer only has a PS/2 port, your will need to use the
CAUTION: Always turn off your computer before connecting or disconnecting any
To connect to a: | Do this: | |||
|
|
|
|
|
USB Port | Plug the cable into your computer’s USB port (or a USB | |||
|
|
|
| port on a hub connected to your computer). You do not |
|
|
|
| need to turn off your computer before connecting or dis |
|
|
|
| |
|
|
|
| connecting a USB device. |
|
|
|
|
|
PS/2 mouse port | Plug your mouse cable into the | |||
|
|
|
| plug the adaptor into your computer’s PS/2 port. |
|
|
|
| |
|
|
|
|
|
INSTALLING YOUR iWHEELWORKS SOFTWARE
In order to take full advantage of your mouse, you must install the enclosed software. While your input device will work as a basic mouse once it is plugged in, the software must be loaded for the programmable third key to work.
To install from Windows® 95/98/Me/NT/2000:
1.Insert the Mouse SETUP DISK into your floppy disk drive. 2.Click the Start button and then click Run.
3.Now type <drive>:\setup. For example, if the Mouse SETUP DISK in is drive A, type a:\setup.
4.Now click OK Follow the
Note: If you do not restart your computer, the software will not operate. 5.Once restarted, the mouse icon 8 should appear in the Windows® system tray. Double click the icon to bring up your mouse control panel.
1