Nortel Networks CG030601 manual Using CLI to configure, Using Web GUI to configure

Page 9

Configuration Guide

Contivity Secure IP Services Gateway

Frame Relay on Contivity Secure IP Services Gateway

a full enquiry interval of 6, the CES transmits a full status inquiry every 60 seconds. With a polling interval of 20 and a full enquiry interval of 30, the CES transmits a full status inquiry every 10 minutes (600 seconds).

Using CLI to configure

To configure the full enquiry interval, navigate to the serial interface and enter:

Frame-relay lmi-n391dte <integer>

<integer> is the full enquiry interval, from 1 to 255. The default is 6.

Using Web GUI to configure

To set the connection type, Frame Relay management type, polling interval, and the full enquiry interval, follow these steps:

1.Bring up the WAN Interface screen (Figure 3), for the interface you are configuring.

2.Click Configure to get the next screen (Figure 4).

Figure 4 Frame Relay Interface screen

3.For the Connection Type field, select Switched if CES connects directly for Frame Relay switch, or Direct if CES is back to back with another CES.

4.For LMI type field, select Frame Relay management

5.For LMI Poll Interval Timer field, enter the Frame Relay polling interval

6.For LMI Poll Interval Counter field, enter the full enquiry interval.

CG030601

2.00

July 2003

Page: 9 of 14

Image 9
Contents Introduction to Frame Relay Permanent virtual circuitsFrame Relay packets ITU-T formerly Ccitt standards do not use this bit Management protocolsAddress resolution for PVCs Committed information rateCommitted burst rate and excess burst rate Congestion control CESconfig-if# filter deny all CESconfig#interface serial 6/1 CESconfig-if#CESconfig-if# data-rate CESconfig-if#frame-relay connection-type switchedWAN Interface list screen Selecting a management type Configure WAN InterfaceConfiguring polling interval using CLI Configuring management type using CLIPolling interval Full enquiry intervalUsing CLI to configure Using Web GUI to configureFrame-relay lmi-n391dte integer Configuring Frame Relay virtual circuits CESconfig-subif# dlci CESconfig-subif#dlci integerCESconfig-subif#traffic-shape 5000 4000 CESconfig-subif#ip local address maskFrame Relay Virtual Circuits Using the Web interface to configureAdd Virtual Circuit Screen Technical Support Contact Information