Nortel Networks CG030601 manual WAN Interface list screen

Page 6

Contivity Secure IP Services Gateway

Frame Relay on Contivity Secure IP Services Gateway

Enabling Frame Relay using Web interface

1. Click System->Wanto bring up the following screen:

Figure 2 WAN Interface list screen

2.In the Select column, click the radio button beside the Interface you want to configure.

3.Click Configure to get the next screen (illustrated in Figure 3).

CG030601

2.00

July 2003

Page: 6 of 14

Image 6

Contents Introduction to Frame Relay Permanent virtual circuitsFrame Relay packets Management protocols ITU-T formerly Ccitt standards do not use this bitAddress resolution for PVCs Committed information rateCommitted burst rate and excess burst rate Congestion control CESconfig-if# data-rate CESconfig#interface serial 6/1 CESconfig-if#CESconfig-if# filter deny all CESconfig-if#frame-relay connection-type switchedWAN Interface list screen Configure WAN Interface Selecting a management typePolling interval Configuring management type using CLIConfiguring polling interval using CLI Full enquiry intervalUsing CLI to configure Using Web GUI to configureFrame-relay lmi-n391dte integer Configuring Frame Relay virtual circuits CESconfig-subif#traffic-shape 5000 4000 CESconfig-subif#dlci integerCESconfig-subif# dlci CESconfig-subif#ip local address maskUsing the Web interface to configure Frame Relay Virtual CircuitsAdd Virtual Circuit Screen Technical Support Contact Information