Nortel Networks 5030 installation instructions Before You Begin, Package Checklist

TM

HotWire 5030 POTS Splitter Customer Premises

Installation Instructions

Document Number 5030-A2-GN10-10

October 1997

Before You Begin

Verify that:

The local loop POTS service is connected to the POTS/DSL network at the punchdown block or network interface device (NID).

New or existing unshielded twisted-pair wiring (CAT3 or better) is used with this product. The CAT3 wiring must meet EIA/TIA-568 specifications with 24 AWG (.5 mm) or 26 AWG (.4 mm).

For RADSL (Rate Adaptive Digital Subscriber Line) RTU installation information, refer to the appropriate RTU document:

Package Checklist

Verify that your package contains the following:

POTS splitter and housing with closure screw

Small plastic bag with two 8±15 x 1″ Type A combination Phillips/slotted-head screws and two 1″ plastic anchors

Warranty card

Tools Required

Flat-blade screwdriver to tighten terminal screws

3/8″ nut driver to close housing securely

Phillips-head or combination Phillips/slotted-head screwdriver to mount the housing

Drill and 3/16″ drill bit to mount the housing in cement or cinder block

1