Nortel Networks 5030 installation instructions Mounting the Pots Splitter Housing

Page 3

Mounting the POTS Splitter Housing

The POTS splitter can be placed:

HOn the outside of the structure near the NID or punchdown block, or

HInside the building.

When mounted outside, the POTS splitter must be installed at or above the height of the NID, and should be a minimum of three feet above ground.

At the front of the housing, align the housing to open from the right with the rubber grommet for cable access facing downward. Place the housing upright as shown. Use a Phillips-head or combination Phillips/slotted-head screwdriver and the screws included in the package.

If mounting to:

POTS Splitter Housing

HCement or cinder block: use a drill and

and 3/16″ masonry drill bit to install the two plastic anchors first. Then, install the two 8±15 x 1″ Type A screws.

H Wood: install only the two 8±15 x 1″ Type A screws and discard the plastic anchors.

97-15247

3

Page 2 Page 4
Image 3
Page 2 Page 4
Contents Package Checklist Before You BeginTools Required Network Service Provider What Does the Pots Splitter Do?Customer Premises CP Pots Splitter Housing Mounting the Pots Splitter HousingPreparing the Pots Splitter ProcedurePunchdown Block Installing the Pots Splitter WiringPots Splitter Reconnecting to the Local Loop Procedure Snap the lever shut to close the Pots splitter DSL DSL Access Wiring ProcedurePots Splitter Technical Specifications Important Safety Instructions Warranty, Sales, and Service Information
Top Page Image Contents