Nortel Networks 5030 installation instructions DSL Access Wiring Procedure, Dsl

Page 9

DSL Access Wiring

"Procedure

1.Attach new wiring to the T1/R1 connectors that will go to the DSL jack from the punchdown block or NID.

2.Tighten the T1/R1 terminal screws with a flat-blade screwdriver.

POTS Splitter

Punchdown

Block or NID

Central

Office

POTS/DSL

Local Loop

Demarcation Point

Customer Premises

DSL

RJ11

Jack

Twisted

Pair Wiring

97-15485

You are now ready to run the specified wiring to the RTU location and install a DSL wall jack. To install an RTU, refer to the HotWire 5446 Remote Termination Unit (RTU) Customer Premises Installation Instructions.

If the RTU is not being installed at this time, reconnect the local loop wiring at the demarcation point.

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents
Package Checklist Before You BeginTools Required Network Service Provider What Does the Pots Splitter Do?Customer Premises CP Pots Splitter Housing Mounting the Pots Splitter HousingPreparing the Pots Splitter ProcedurePunchdown Block Installing the Pots Splitter Wiring Pots Splitter Reconnecting to the Local Loop Procedure Snap the lever shut to close the Pots splitter DSL DSL Access Wiring ProcedurePots Splitter Technical Specifications Important Safety Instructions Warranty, Sales, and Service Information
Top Page Image Contents