Nortel Networks 5000i manual Standalone Installation, Computer XE Standalone installationComputer

Standalone Installation

The 5000i scanner in a standalone configuration requires a computer, a monitor, a keyboard, a mouse, and a table (for the monitor, keyboard, and mouse). An optional printer may also be installed.

tiger009

Figure 3 – 1: Standalone Configuration

Computer{ XE "Standalone installation:Computer" }

This section discusses installation and internal cabling for the computer in a standalone configuration.

Installation

Before installing { XE "Computer:standalone checkout" }{ XE "Computer:Preparing for standalone installation" }the computer in the scanner, do the following.

1.Use your fingers (or a screwdriver) to remove the screw (knurled knob) at the rear of the computer (center-top) and lift off the cover. Some models have green plastic covered screws, and some have two screws.

CAUTION: Use ESD precautions (including a grounded wrist strap) for steps 2, 3, and 4.

2.Make sure that the scanner interface cards and all ribbon cables are fully seated.

3.Remove the Catgut board{ XE "Catgut board" } from its separate packaging and do the following:

•Ensure that the three 40-pin DIP and one 40-pin SIP headers which connect the Catgut II board to the Catgut I board are fully seated.

•Ensure that the SIMMs on the Catgut II{ XE "Daughter card (Catgut II)" }{ XE "Catgut II (daughter card)" } board are fully seated.

Chapter 3. Computer and Peripherals Installation Page 21