Nortel Networks 5000i manual Internal Cable Connections XE Internal cable connections

Page 42

Board/Connector Relationship

Figure 3-4 illustrates the relationship between PC boards{ XE "Network installation:Board/connector relationship" } attached to the bulkhead inside the cabinet and the connectors on the exterior surface of the cabinet in a network configuration.

 

No Board Required for

 

Monitor (Pass Through)

 

KEMCON

MONITOR

 

 

KEYBOARD MOUSE

 

SCANNER

CAMERA

CONTROLLER

MAIN BOARD

CONTROLLER

 

BOARD

 

PRTCON

 

NETCOM

 

LINE PRINTER

INPUT POWER

 

NETWORK

 

 

tiger022

Figure 3 – 4: Network Board/Connector Locations

Internal Cable Connections{ XE "Internal cable connections" }

This section provides additional information regarding connection of the monitor, keyboard, mouse, cameras, power, network, and printer (optional) cables to the appropriate connectors on the boards located inside the scanner (Figure 3-4).

The PRTCON, NETCON, and KEMCON, boards are attached to the interior of the scanner's bulkhead to provide an appropriate exterior connection to both standard and optional devices.

The PC boards include the following:

Scanner Controller main board (bed control logic).

Camera Controller board (camera, light source, and pixel normalization logic).

NETCON board (Network).

KEMCON board (Keyboard and mouse).

PRTCON board (Printer, optional).

The schematic in Figure 3-5 identifies the cable connections to the appropriate boards and the appropriate connections of these cables to ports on the computer. The scanner is shipped with the

Page 30

5000i Scanner Installation Guide

Image 42
Contents Installation Guide For the 5000i Scanner Page Installation Guide For the 5000i Scanner For Users in the United States Revision Log Tab/Rev Date DescriptionIii 5000i Scanner Installation Guide Preface System Component Manual Title5000i Scanner Installation Guide Table of Contents Viii 5000i Scanner Installation Guide Introduction Introduction5000i Scanner Installation Guide Scanner Overview Overview of the Scanner XE Scanner, 5000iOverviewScanner Overview Scanner Installation Guide Technical Support for Hardware Problems Customer SupportTechnical Support for Software Problems Scanner Overview Hardware Scanner InstallationPreparation SoftwareInstallation Checking the Installation SiteScanner Installation 5000i Scanner Installation Guide Installing the Scanner Spares XE Spares kit, contentsUnpacking the Scanner Power Noise GroundingCondition Description Dedicated Ground 5000i Scanner Installation Guide Scanner Installation Site Power Wiring Recommendations Power Frequency Limits Voltage Limits Other Data +12V Boost Power Supply Location of the Power SuppliesPage Location of the Power Supplies Scanner Installation Installation of Computer and Other Peripherals Shut DownInstallation Standalone InstallationComputer XE Standalone installationComputer Computer and Peripherals InstallationCabling Monitor XE Standalone installationMonitor Work TableMonitor and Keyboard Board/Connector Relationship Standalone Board/Connector LocationsNetwork Installation XE Scanner, 5000iNetwork configuration Computer5000i Scanner Installation Guide Cabling Monitor XE Network installationMonitor Keyboard and Mouse XE Network installationKeyboard and mouse Network Board/Connector Locations Internal Cable Connections XE Internal cable connectionsComputer and Peripherals Installation Cable Part XE Cable part numbers Numbers and Connections Part Number Description Type PC ConnectionNetwork Printer XE Network installationPrinter optional Optional EquipmentSystem Printers Bar Code Reader Computer and Peripherals Installation System Verification XE CheckoutSystem verification Scanner CheckoutSystem Software RequirementsScanner Checkout 5000i Scanner System Software Scanner Checkout 5000i Scanner Installation Guide Index Index5000i Scanner Installation Guide