Nortel Networks
555-7101-215
manual
Publication history
Install
Rear panel diagram
Connecting the server to power
Dimension
Remote access connectivity
Sample network setup Meridian
To connect the server to power
Front panel features
Switch connectivity
Page 6
Publication history
Standard 1.0
vi
CallPilot
Page 5
Page 7
Image 6
Page 5
Page 7
Contents
CallPilot
P0604536
CallPilot
Page
Publication history
Publication history
Contents
Contents
702t server description
A p t e r
Server features
Server dimensions
Introduction
Front panel features
702t server descriptionStandard
Rear panel diagram
Refer to Slot assignments on page 14 for slot assignments
Slot assignments
Slot definition and slot numbering
Slot assignments 702t server with RAID
BRD01
Slot assignments 702t server without RAID
IRQ mapping table
Slot 5 RAID/On-Board Scsi controllers
Network connectivity
Sample network setup Meridian
Customer LAN optional
Sample network setup Succession CSE
Telephony LAN/Customer LAN 10/100BaseT or 100BaseT
Switch connectivity
LAN connectivity
Remote access connectivity
Network requirements
Supported peripheral devices
Preinstallation requirements
Installation overview
Installation checklist
May 2003Preinstallation requirements
Conventions for warnings
Unpacking the 702t server
To unpack the equipment
What’s next?
Removing the side panel
To remove the side panel
Bottom
May
Inspecting the server interior
Protective foam
To remove protective foam and inspect the server interior
Then
Preinstallation requirements
Installing the server and connecting the peripheral devices
Installing the server
To install the server
Preparing the modem
Required equipment
Modem DIP switches
DIP
To set the modem DIP switches
OFF
Nvram
Connecting peripherals to the server
Before you begin
Rear panel
To connect the mouse, keyboard, and monitor to the server
To connect the modem to the server
Connecting the server to the Elan
Media Access Control address
To connect the server to the Elan
Feature key adapter dongle. See
Connecting the server to the Clan optional
To connect the server to the Clan
What’s next?
Installing the Nortel Networks software feature key adapter
To install the software feature key adapter
Requirements
Connecting the server to power
CallPilot server
To connect the server to power
To start the server
Binder
Installing the server and connecting the peripheral devices
EMC emission level protection for the 702t Server
P e n d i x a
Ferrites secured to an external cable
Index
NIC
May Index
Index
Page
Product release Document release Standard Date May
Top
Page
Image
Contents