Nortel Networks BSR222 manual Rear panel, Power

Page 15

Chapter 2 Hardware installation 15

2.2 Rear panel

Table 3 Rear panel details

LABEL

DESCRIPTION

 

 

Step 3

Connect the included power adaptor (use only this adapter) to this

POWER

power socket.

 

 

 

After you have made the connections, connect the power cable to a power supply and look at the front panel LEDs. The power LED blinks while performing system testing and then stays on if the testing is successful. The Ethernet port LEDs turn on if the ports are properly connected. Refer to Configuring and Troubleshooting the Nortel Business Secure Router 222 for more detailed LED descriptions.

CON/AUX port,

Only connect this port if you want to configure the Business Secure

CON/AUX

Router using the SMT via console port. See your User's Guide for

switch

details.

 

Set this switch to the CON (Console) side to use the CON/AUX port as

 

a console port for local device configuration and management. Connect

 

the 9-pin male end of the console cable to the console port of the

 

Business Secure Router and the other end to a serial port (COM1,

 

COM2 or other COM port) on your computer. Your computer must have

 

a terminal emulation communications program (such as

 

HyperTerminal) set to VT100 terminal emulation, no parity, 8 data bits,

 

1 stop bit, no flow control and 9600 b/s port speed.

 

 

RESET

Press this button for one to three seconds to restart the Business

 

Secure Router. Press this button for longer than three seconds to

 

return the Business Secure Router to the factory defaults (password is

 

setup, LAN IP address 192.168.1.1, terminal emulation settings as

 

described above; see your User's Guide for details).

 

 

Nortel Business Secure Router 222 — Fundamentals

Image 15
Contents Nortel Business Secure Router 222 Fundamentals Trademarks Copyright NortelContents Chapter User Notes Page NN47922-301 Before you begin PrefaceRelated publications Hard-copy technical manuals How to get help AC Power Adapter Specifications Internet account information worksheet Chapter Introducing the Business Secure RouterIntroducing the Business Secure Router NN47922-301 Chapter Hardware installation Label Description Front panelRear panel PowerHardware installation NN47922-301 Static or dynamic configuration Windows 2000/NT/XP Chapter Setting up your computer IP addressSetting up your computer IP address Checking your computer IP address Command PromptSetting up your computer IP address NN47922-301 Accessing your Business Secure Router via the WebGUI Chapter Configuring your Business Secure RouterConfiguring your Business Secure Router Configuring your Business Secure Router Using the wizard to configure for internet access Configuring your Business Secure Router Internet connection with ethernet Internet connection with PPPoE Internet connection with Pptp WAN IP address assignment System DNS servers Test your internet connectionChapter User Notes General NotesGeneral VPN Client Termination FirewallUser Notes Routing SecurityAdvanced Router Configuration Setting up the router when the system has a serverConnecting two sites to establish a virtual private network Adding IP telephony to a multi-site network Allowing remote management of a LAN-connected BCM50 Preventing heavy data traffic from impacting telephone calls Setting up the router for guest accessSetting Up a Remote Office with a UNIStim IP Telephone VPN Connections With Cisco Routers Inter-Operability With Third-Party RoutersProblem You cannot ping any computer on the LAN Chapter TroubleshootingProblem You cannot access the Internet Problem You cannot get a WAN IP address from the ISP