Tektronix 780 setup guide User safety summary, Terms in manual Caution

Page 5

User safety summary

Terms in manual: CAUTION

Conditions that can result in damage to the product.

WARNING

Conditions that can result in personal injury or loss of life.

Power source: Do not apply more than 250 volts RMS between the supply conductors or between either supply conductor or ground. Use only the specified power cord and connector. Refer to a qualified service technician for changes to the cord or connector.

Operation of product: Avoid electric shock by contacting a qualified service technician to replace fuses inside the product. Do not operate without the covers and panels properly installed. Do not operate in an atmosphere of explosive gases.

Safety instructions: Read all installation instructions carefully before you plug the product into a power source.

Terms on product: CAUTION

A personal injury hazard exists that may not be apparent. For example, a

 

panel may cover the hazardous area. Also applies to a hazard to property

 

including the product itself.

DANGER

A personal injury hazard exists in the area where you see the sign.

Care of product: Disconnect the power plug by pulling the plug, not the cord. Disconnect the power plug if the power cord or plug is frayed or otherwise damaged, if you spill anything into the case, if product is exposed to any excess moisture, if product is dropped or damaged, if you suspect that the product needs servicing or repair, and whenever you clean the product.

Ground the product: Plug the three-wire power cord (with grounding prong) into grounded AC outlets only. If necessary, contact a licensed electrician to install a properly grounded outlet.

Symbols as marked on product:

DANGER high voltage:

Protective ground (earth) terminal:

Use caution. Refer to the manual(s)

 

 

for information:

Hot surface on or in the printer.

This product is certified under IEC

Use caution to avoid personal

825 as a Class 1 Laser Product:

injury:

 

WARNING: If the product loses the ground connection, usage of knobs and controls (and other conductive parts) can cause an electrical shock. Electrical product may be hazardous if misused.

WARNING: For your protection, do not defeat any interlocks.

Page 4 Page 6
Image 5
Page 4 Page 6
Contents S E R P R I N T E R Phaser 780 Color Laser Printer Setup Guide Pantone, Inc Phaser 780 Color Laser Printer Warranty Terms in manual Caution User safety summaryFor Users in Japan At a glance Getting Set UpFuser roll cartridge What you get with your printerOptions and accessories 70 kg 153 lbs Select a location59 m 62.5 61 m 63.7 150 mm 6 503 mm 551 mm 21.7 835 mm 32.5 T E Set up the printerLoad the toner cartridges 3094-71 Unpack the matching toner cartridge Shake the toner cartridge vigorously, seven or eight times U T I O N Install the imaging unit 3094-32 Set the two blue switches to the lock position Install the fuser roll cartridge Remove the two shipping inserts 3094-38 Push in the lower left unit Attach the multi-purpose tray and output extensions Push in the multi-purpose tray Unpack the output tray a. Orient it as shown b 3094-47 Turn on the printer Noises the printer makes as it warms up are normal Select a language for the front panel Load the paper tray 3094-53 Readjust the paper guides to the correct paper size Push in the paper tray Press Print Make a test printAttach the User Guide Printer ports Connect the printerConnect to a PC Set up the printer on a networkConnect optional peripheral devices PC/Windows software Install printer softwareInstalling the driver If you are setting up the printer on a network Configuring the driver Macintosh software Select Custom Install Setting up the driver Register your printer Task / Information needed Resource Where Where to go from herePhaser 780 Color Laser Printer
Top Page Image Contents