Chapter 5
Getting Help
Your LabelWriter printer should offer years of
For complete information about programming and using the LabelWriter SE450 printer, refer to the LabelWriter SE450 Technical Reference Guide, available from the Developers Program page on the DYMO Web site (www.dymo.com).
Troubleshooting
This section provides information on how to detect and correct problems you might encounter while using your LabelWriter printer.
Status Light
The status light visually shows the current state of the printer:
Status Light | Description |
|
|
Solid Blue | Power is on and printer is ready. |
|
|
Dimmed Blue | Printer is in power saving mode. |
|
|
Flashing Blue | Labels are not loaded properly or the label roll is empty. |
|
|
For the LabelWriter SE450, the status light shows the current state of the printer as follows:
SE450 Status Light | Description | |
|
| |
Solid Blue | USB cable is connected. Power is on and printer is ready. | |
|
| |
Dimmed Blue | USB cable is connected and printer is in power saving mode. | |
|
| |
Flashing Red | Labels are not loaded properly or the label roll is empty. | |
|
| |
| Serial cable is connected. Power is on and printer is ready. Printer will also show | |
Solid Green | solid green when both USB and Serial cables are connected or when no cables | |
| are connected. | |
|
| |
Dimmed Green | Serial cable is connected and pirnter is in power saving mode. | |
|
| |
| Serial cable is connected and printer is in configuration mode. For complete | |
Flashing Green | information about programming and using the LabelWriter SE450 printer, refer | |
to the LabelWriter SE450 Technical Reference Guide, available from the | ||
| ||
| Developers Program page on the DYMO Web site. www.dymo.com | |
|
|
19