Charging the Battery
A charging adapter is included with your label maker for recharging the battery pack. Charging the battery pack will take approximately three hours.
The charging adapter is only used for recharging the battery pack; the charging adapter cannot be used to power the label maker.
To recharge the battery
1 Plug the charging adapter into the power connector on the top of the label maker.
2Plug the other end of the charging adapter into a power outlet.
Make sure to read the LiPo Safety Precautions found on page 15.
Inserting the Label Cassette
Your label maker uses DYMO D1 label cassettes.
To insert the label cassette
1 Lift the back cover of the label maker to open the label compartment.
2 Make sure the tape and ribbon are taut across the mouth of the cassette and that the tape passes between the label guides.
If necessary, turn the ribbon rewind spool clockwise to tighten the ribbon.
3 Insert the cassette and press firmly until the cassette clicks into place.
4 Close the back cover of the label maker.
3