Dymo 450 manual About Your New Labelmaker, Getting Started, Connecting the Power

About Your New Labelmaker

With your new DYMO LabelMANAGER™ 450 labelmaker, you can create a wide variety of high- quality, self-adhesive labels. You can choose to print your labels in many different sizes and styles. The labelmaker uses DYMO D1 tape cassettes in widths of 1/4” (6 mm), 3/8” (9 mm), 1/2” (12 mm), 3/4” (19 mm), or 1” (24 mm). Tape cassettes are also available in a wide range of materials.

Visit www.dymo.com for information on obtaining labels and accessories for your labelmaker.

Warranty Registration

Please complete the warranty registration card and return it to the appropriate customer service address within seven days of purchase. Visit www.dymo.com for details.

Getting Started

Follow the instructions in this section to print your first label.

Connecting the Power

The labelmaker can operate on AC or battery power. To save power, the labelmaker will automatically turn off after two minutes of inactivity.

Inserting the Batteries

The labelmaker uses six 1.5 volt high-capacity AA alkaline batteries.

1.Remove the battery compartment cover. See Figure 2.

Figure 2

2.Insert the batteries following the polarity markings (+ and –).

3.Replace the battery compartment cover.

Remove the batteries if the labelmaker will not be used for a long period of time.

Connecting the Power Adapter

Connecting the power adapter to the labelmaker disconnects the batteries as a power source.

To connect the power adapter

1.Plug the power adapter into the power connector on the top, left side of the labelmaker.

2.Plug the other end of the power adapter into a power outlet.

Inserting the Tape Cassette

Your labelmaker comes with one DYMO D1 tape cassette. Visit www.dymo.com for information about purchasing additional tape cassettes.