SATO 9001147B manual Ascii

Click on the scoll-down arrow for the Type field and select the Alien - EPC (class 1) 64 bit menu option or the type of inlay desired.

Next, click on the scoll-down arrow for the Data Type field and select either ASCII or Hex Encoded String option.

ASCII	Allows the data to be entered as full ASCII table and the
	software changes over to HEX when sending it to the
	printer. For a 64 bit tag selection, eight (8) digits must
	be used and for a 96 bit selection, twleve (12) digits
	must be used.
HEX	Allows the data to entered using 0 through 9 and A
	through F. The exact data is sent to the printer’s chip.
	For a 64 bit tag selection, sixteen (16) digits must be
	used and for 96 bit selection, twenty-four (24) digits
	must be used.

Note that this data may also be substituted with a variable previously created in Label Gallery by selecting the Variable option for the Data Source ratio.

EPC encoding translators may also be used by selecting that relative box on the screen. When checked, select the type of EPC encoding you wish to use and then fill in the data values which show up as shown on the following screen.

SATO RFID User Guide PN 9001147B Page 7