EURO SET-UP
To set the currency for conversion to Euros:
•Press + and then C . The display will
showthe previously selected currency and its conversion rate into Euros, eg:
BEF BF40,3399
•Use or to step through the currencies available: Austria: 13,7603 öS
Belgium: BF 40,3399
Germany: DM 1,95583
Spain: 166,386 Pts
Finland: 5,94573 mk
France: 6,55957 Fr
Ireland: £ 0.78756
Italy: L1936,27
Luxembourg: LF 40,3399 e1 = _
Press | to confirm the selection. |
| C |
•The next time that you press C or + C , the
conversion will be between Euros and the chosen currency.
The line showing e1 = _ is
Symbols and special characters
INTERNATIONAL CHARACTERS
To add a diacritical (accent) to create an international character, enter the character first, followed immediately
by the diacritical, e.g. press E followed by / | to |
get é. |
|
To add a diacritical to an existing character, use | or |
to place the cursor under the character to the right of the character to be changed, then press the appropriate diacritical key.
SYMBOLS
SYMBOLS +
•Press to show symbols and special characters, some of which are not available direct from the keyboard. The
display will show the last used symbol character, for
example: A1 with a line of symbols above it. Each letter selects a line of symbol characters, numbered 1 to 6, as shown in the table on page 2.
• Press DEL to cancel, or
•Press a letter key ‘A’ to ‘Z’ until you find the line of symbols required. You can then press a number key ‘1’
to ‘6’ to select the symbol required.
Alternatively, use or to step through the rows A to Z, then use or to move the cursor under the symbol required.
Press to place the symbol in the label.
PRINT CONTRAST — may be adjusted by pressing
+ | SYMBOLS |
followed by PRINT to display the contrast |
symbols .
•Use or to select lighter or darker print.
•Press to confirm the setting. The contrast level will revert to the
Note: This function enables you to adjust the print quality under extreme temperature conditions.
Cleaning
•Clean the cutter blade regularly: Press and hold down cutter lever E to expose cutter blade D➊, then use a cotton bud and alcohol to clean both sides of the blade. Release cutter lever E.
•Check and clean print head face D➋ regularly using a cotton bud and alcohol ONLY.
Troubleshooting
No display
•check machine is on
•replace discharged batteries
•check AC adaptor.
No printing or poor text
•replace discharged batteries
•check tape cassette installed correctly
•clean the print head
•replace the tape cassette.
Poor print quality with white ink
•When using a White on Black or a White on Clear cassette, it may be necessary to use the darkest contrast setting in order to obtain good print quality. To change the contrast setting via the keyboard, read and follow the instructions as described in the paragraph “Print Contrast”.
Tape jammed
•lift out tape cassette carefully
•remove/release jammed tape
•DO NOT cut the ink ribbon – turn spool B➎ to tighten
•cut off excess label tape
•refit/replace the tape cassette.
Poor cutter performance
•clean the cutter blade regularly
No response to print key
•!!!!!!!!!!!!!!! in the display indicates a printer jam. Press any key to return to normal display. Open the cassette compartment and free the jam.
• |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| flashing in the display |
indicates discharged batteries. Press any key to return to normal display. Replace the batteries.
No success?
•Call the DYMO customer service hotline telephone number in your country – see the warranty booklet.
8