RCA MultiMedia Monitor manual Channel Marker, PIP Problems?

MENUS AND FEATURES

PIP Problems?

•Make sure the remote is in the right mode. For example, once you turn on the VCR with the VCR1 button, you can’t SWAP the pictures until you put the remote in TV mode. Just press the TV button.

•No signal or bad reception? Most VCRs and satellite receivers have an antenna or TV button. If your cable or off-air antenna goes into your VCR or satellite receiver, then into your monitor, try pressing the antenna or TV button on the front of the component.

Tip: If programmed to control your VCR, the ANTENNA button on the remote acts as a TV/VCR button.

•Check the connections. PIP requires a second video source, like a VCR or satellite receiver, connected to your monitor with audio/ video cables. If you use a cable box, you may need extra equipment. Contact your cable company for more information.

VCR

IN

OUT

++

To see a different picture in the PIP window, you must connect another video source, like a VCR. This connection requires audio/video cables.

CHANNEL MARKER

There are several indicators that come up when you press the TV, INFO, PIP or SWAP button. This display is called the Channel Marker.

12:01 Displays the current time.

CCDisplayed when Closed Captioning is available on the current channel.

VCR1 Displays the label assigned to the current channel.

VID1 Displays the current channel or input channel.

Mute (or Stereo) Mute is displayed when you mute the audio. Stereo is displayed when the current channel is broadcasting in Stereo.

PIP 59 (PIP Chan) Displays the current PIP channel.

00:00 Displayed to count down time left on the commercial skip (SKIP) timer.

12:01	CC VCR1 VID1
Mute	PIP 59

00:00

Sample displays on a Channel Marker

49