Regulator TH1 31 -R
User Guide
C o n tro l M o d u l e
Heating
Command
Indicator Light
ON/OFF
Switch
Power Selection Dial
Introduction
Thank you for choosing Aube’s
The
The
This control module can be used with a line voltage power base (230 V European models) or a low voltage power base (24 V) combined with an electromechanical or triac relay.
Configure the Switch
Located in the
230 V LINE VOLTAGE BASE
ALWAYS 15 minutes
24 V LOW VOLTAGE BASE
•15 MIN
Use with a triac or electromechanical relay. Recommended for mechanical actuated system (water heating using a solenoid valve, etc.) or a
•15 SEC
Use only for installations with SSR TRIAC relay. Recommended for electric heating (baseboards, convectors, etc.).
The
Install the Control Module
Align the bracket tabs on the control module with the holes located on the power base and secure using the screw.
Control Module | Air Vents |
|
Air Vents | Power Base |
NOTE: Keep the regulator’s air vents clean and free from obstructions.
NOTE: The screw cannot be removed completely.
Operation
Technical Specifications
Warranty | Service |
The
For example
heat for 50% of the cycle; it will be ON
for 7.5 minutes and OFF for 7.5 minutes.
Below is a detailed table of the cycle duration based on the dial’s position:
Position and | I | 2 | 4 | 6 | 8 | 10 |
equivalent % | 0% | 20% | 40% | 60% | 80% | 100% |
|
|
|
|
|
|
|
ON | 0 min | 3 min | 6 min | 9 min | 12 min | 15 min |
OFF | 15 min | 12 min | 9 min | 6 min | 3 min | 0 min |
|
|
|
|
|
|
|
NOTE: Depending on the power base used, the heating cycles can be 15 seconds or 15 minutes.
Model:
Setting Range: from 0 to 100%
Storage:
Heating cycles:
Size (H/W/D): 3,1 x 3,1 x 0,64 in. (78,9 x 78,9 x 16,3 mm)
Available Relays
Electric Heating Solid State Relay:
RT850 this model handles 100 to 347 V.
RT850T this model has a
Electric Heating Electromechanical Relays:
RC840 this model handles 120 to 347 V.
RC840T this model has a
AUBE TECHNOLOGIES INC. TWO (2) YEAR LIMITED WARRANTY
This product is guaranteed against workmanship defects for a
During this period, AUBE Technologies Inc. will repair or replace, at our option and without charge, any defective product which has been used under normal conditions.
The warranty does not cover delivery costs and does not apply to products poorly installed or randomly damaged following installation.
This warranty cancels and replaces any other manufac- turer's express or implied warranty as well as any other company commitment. AUBE Technologies Inc. cannot be held liable for related or random damages following the installation of this product.
The defective product as well as the purchase invoice must be returned to the place of purchase or mailed, pre- paid and insured, to the nearest address.
If you have any questions concerning the
705 Montrichard | 10 rue Ampère | |
95500 Gonesse | ||
(Quebec) Canada | France | |
J2X 5K8 |
|
|
Tel.: | (450) | 33 (0) 1 34 07 99 00 |
| 33 (0) 1 34 07 99 19 | |
Fax: | (450) |
|
service@aubetech.com | advaube@comintes.com | |
For more information on our products, visit us at
www.aubetech.com
19/12/03