Toshiba 1600EP Series UPS Specifications, Standard Models 3.6kVA-RoHS 3.6kVA 6kVA 8kVA, 3.1 kW1

UPS Specifications

Standard Models: 3.6kVA-RoHS; 3.6kVA; 6kVA; 8kVA

Unit (Capacity)	3.6 kVA-RoHS			3.6 kVA (3.1 kW)1	6 kVA (5.1 kW)1	8 kVA (6.8 kW)1
	(3.1 kW)1
General
Topology				True On-line
Certifications				UL, CUL, ISO 9001, NEMA/PE1-1993
Input Characteristics
Input Voltage			Single-phase, 208/240 Vac, -30% – +10%
Input Frequency				45 – 65 Hz (auto-sensing)
Input Capacity		3.6 kVA			6.0 kVA	8.0 kVA
Input Power Factor				> 0.95 for all loads
Current THD (linear load)				< 5% total harmonic distortion
Included AC Input Breaker		30 A/277 V			50 A/277 V	60 A/277 V
Rating
Battery Characteristics
Battery Type			Valve Regulated Lead Acid, Flame Retardant
Backup time, fully charged	8 min.			14 min.	7 min.
@ 0.7 power factor, 77 °F	minimum2			minimum2	minimum2
Backup time, fully charged	7 min.			10 min.	7 min.
@ 0.85 power factor, 77 °F	minimum2			minimum2	minimum2
Recharge Time		24 hr. (full), 12 hr. (90%) for internal batteries only3
Battery Voltage (Nominal)	144 Vdc			216 Vdc	216 Vdc	288 Vdc
Output Characteristics
Output Voltage				Single-phase, 240/208/120 V
Output Voltage Regulation			± 3%
Output Frequency	±0.5 Hz/1 Hz/1.5 Hz (factory or authorized service center selectable only)
AUTO/MAN Frequency	Factory or authorized service center selectable only
Voltage THD			< 3% for linear load; < 6% for non-linear load
Common-Mode Noise				< 0.5 Vrms
Rated Load Power Factor				0.85 (0.6 – 1.0) lagging
Efficiency (ac-dc-ac)				> than 83% (without battery charge)
Voltage Transient				< ±8% (Load of 0 – 100 %)
Rated Output Current (rms)			15 A		25 A	33.3 A
Max. Peak Output Current			45 A		75 A	100 A
Inverter Overload Capacity				125% for 30 sec./150% for 10 sec.
Bypass Overload Capacity				125% for 10 min./1000% for 1 cycle
Crest Factor			3.0

1.Input/output figures rated for 240 volts. Output ratings given for 0.85PF are only valid when the input voltage is greater than 204 volts; otherwise, ratings given for 0.70PF are applicable.

2.Battery backup time may vary depending on the operating conditions and ambient temperature at the installation site.

3.An initial charge time of 24 hrs. is necessary to obtain proper battery performance level before unit is placed in operation.

1600EP Series Instruction Manual 15