Operating Precautions
1.The UPS should not be powered up until the entire operation manual has been read.
2.The voltage of the input power source must be within the range of +10% to
3.The UPS should not be used with a load that has a rated input that is greater than the rated output of the UPS.
4.DO NOT use the UPS to provide power to motors that require high starting current or with motors that require a long starting time, such as vacuum cleaners and machine tools (oversizing the UPS for lock rotor current would be required).
5.DO NOT insert metal objects or combustible materials in the ventilation slots of the UPS.
6.DO NOT place, hang, or paste any objects on the exterior surfaces of the UPS.
7.The capacitors of the UPS maintain a residual charge for a while after turning the UPS off. The required discharge time for each UPS typeform is provided via a cabinet label and a CHARGE LED. Wait for at least the minimum time indicated on the label and ensure that the CHARGE LED has gone out before opening the door of the UPS once the UPS power has been turned off.
8.DO NOT attempt to disassemble, modify, or repair the UPS. Call your Toshiba sales representative for repair information.
9.Turn the power on only after installing ALL of the covers.
10.DO NOT remove any covers of the UPS when the power is on.
11.If the UPS should emit smoke, produce an unusual odor, or make sound, turn the power off immediately.
12.The heat sink and other components may become extremely hot to the touch. Allow the unit to cool before touching these items.
13.Warning signs should be placed on or near the load as a notification that the load is being powered by the UPS.
14.Additional warnings and notifications shall be posted at the equipment installation location as deemed required by Qualified Personnel.
Warning
When operating in the inverter mode, placing the breaker in the OFF position will switch the UPS to the battery backup mode. The output of the UPS will continue uninterrupted to the load. The unit must be in the bypass mode at the time that the breaker is placed in the OFF position for the UPS to shutdown power to the load.
caution
Wait at least 5 minutes after an Emergency Power Off (EPO) before resetting the UPS breaker. This allows the UPS circuitry to fully discharge. The UPS could be damaged if the unit is not fully discharged before the breaker is reset.
1600EP Series Instruction Manual