RCA RMB-167 manual Start-Up, Connections, Jumper Settings, Software Initialization, Serial Number

Page 10

3 START-UP

3.1Connections, Jumper Settings

1.Connect your RIGEL board to the PC host via a serial cable.

2.Connect the board to a power supply.

The red LED will come on if power is connected correctly

3.Check to make sure jumpers are the correct position. There are two jumpers, one in position P0.4 the other in P0.6. This is the default configuration for the RMB-167 and the board will be populated this way from the manufacturer.

3.2Software Initialization

Run the READS166 host driver by selecting Start Programs READS166. You may also start READS166 by double clicking on the READS166 short cut icon if installed.

3.3Serial Number

3.3.1 Demo Version

When you run the READS166 software a pop-up registration box will open asking for your serial and customer numbers. If you are using the demo

version of the software you may press CANCEL and the box will disappear and the About Box will appear. Press the OK button in the About Box and the software will run in the Demo mode. The demo mode limits the size of the files you can compile to about 8K.

3.3.2 Full Version

If you’ve purchased the READS166 software a

registration sheet with the serial number and customer number will be included with the READS166 User’s Guide. When you run the READS software insert these numbers in the correct boxes, press OK and then press OK in the About Box. Your software is registered and ready to use.

3.4Configuring READS166 and Initiating Host-to-Board Communications

1.Press the Projects Options Project Properties HW Configuration to select the board you are using from the list. Or using the Tools Hardware Configuration menu command, choose the name of the board you are using from the board list which appears.

-4-

Page 9 Page 11
Image 10
Page 9 Page 11
Contents USER’S Guide Page Page Warranty Table Of Contents 10.1.1 Hardware READS166 Evaluation Software OverviewParts List System Requirements Software Installation, READS166Software Third Party SoftwareSoftware Initialization Connections, Jumper SettingsSTART-UP Serial NumberBootstrapping Verifying that the Monitor is Loaded A D S C O M M a N D SSoftware Set-up TroubleshootingHardware Set-up PC set-upSerial port PowerOperating Notes Jumper SelectionEprom Memory Options Memory OptionsRAM Memory Options Alternate Memory Map with Eprom in Low MemoryMoving RMON167 to Eprom Eprom CFG1Rstisr Syscon is 89h on the 167 dw 089E6h Dw 0F800h Nop Mov GAL Equations Default GAL Equations1 U1 Equations U2 Equations Alternate GAL Equations1 U1 Equations For Eprom In Low Memory 2 U2 Equations For Eprom In Low Memory Equations Headers and Jumpers JP6 System Header SignalPins Signal System and I / O HeadersJP7 Input/Output Header Signal 166 JP2 JP7Pins JP8 Extra Input/Output Header of the RMB-167 SignalSignal RMB-167 Analog-to-Digital Converter Reference Jumpers Bootstrapping S0RIRDiswdt Einit Mov R1, #0A55Ah Minimal Monitor Download HEX file Port ConfigurationMON167 Monitor HelpPort Data Word MemoryREADS166 Version READS166 V3.00 ConceptsArchive Projects Executable ProjectsModule Circuit Diagrams
Top Page Image Contents