Configuration | American Power Conversion DP300E series guide

Configuration continued

Management Card Wizard, continued

Accessing the network interface

If the Wizard has not detected the management card after 2 minutes or your workstation is not connected to the network, follow these steps:

1Click Next.

2Select Express.

3Click Next.

4Select Locally (via Serial Port).

5Click Next.

6Follow the on-screen instructions to configure your management card using a serial connection.

If you have configured network settings through the Management Card Wizard and your card was on the network, you had the option to launch a Web browser to view the Silcon management card network interface. If you have used another method to configure your network settings or did not choose to launch a Web browser from the Wizard, you can access the network interface using a Web browser, Telnet, or SNMP. See the appropriate paragraph below for details.

Through a Web browser.

1From your Web browser, enter the System IP address or DNS name, if configured, of the unit.

2Log on to the chassis. The default User Name and

Password are

apc

(lowercase).

Through Telnet.

1From your Telnet session, enter the System IP address of the unit.

2Log on to the unit. The default User Name and

Password are

apc

(lowercase).

Through SNMP.

The default read-only community name is	public		. The
default read/write community name is	private	.

Note: When the management card reports a non-specific fault, it is defined on the screen of your Silcon UPS display unit.

Continued on next page