APC BK400EI, BK600EI, BK250EI user manual StoringtheUPS, StorageConditions, 2ExtendedStorage

Page 33

8.0StoringtheUPS

8.1StorageConditions

The UPS should be covered and stored in an upright position, in a cool, dry location. The UPS should be stored with the battery in a fully charged state. This means that the UPS should be allowed to charge the battery for at least 6 hours before the UPS is switched off for storage.

8.2ExtendedStorage

To achieve expected run time following extended storage, the UPS should be allowed to refresh the battery for 12 hours once every 6 months in environments where the ambient temperature is -15°C to +30°C (5°F to 86°F). For extended storage in environments where the ambient temperature is +30°C to +45°C (86°F to 113°F), the UPS should be allowed to refresh the battery for 12 hours once every month.

Page 31

Image 33
Contents APC Back-UPS ImportantSafetyInstructions PleasesavethismanualPleasesaveorrecyclethepackagingmaterials TableofContents 3Optionswitches 2Userreplaceablebattery0Introduction 1OverviewTest / Alarm Disable switch 5SurgesuppressionandEMI/RFIfiltering6Remoteinterface 0Safety 0Sécurité!Françias Vorsicht 0Sicherheit!Deutsch¡Atencion ¡Seguridad!Español2Placement 0Installation1Receivinginspection 3Loadtypes5Batterycharging 4ConnectingtotheUtilityConnecting Your Equipment to the UPS Example labels found at system equipment rear panels 8Overloads Test for Proper Operation0PrinciplesofOperation Noise and surge suppression 3BatteryCharger 2Loadtransferswitch4Battery 5Inverter6Transformer Monitoring and control electronics8Operationduringautilityfailure Page Power I/0 switch ControlsandindicatorsTest/Alarm Disable switch on units so equipped 3Audiblealarm4OptionSwitches Option Switch #1Option Switch #2 and #3 Option Switch #4 Option Switch #2 Switch #3 Undervoltage Transfer0UPSmonitoring 2PowerChuteSoftware600VAonlyPage 0Difficulty Françias 0Difficulté0SchwierigkeitDeutsch ¡Cuidado 0Dificultad EspañolMo r 1TroubleshootingChart1TroubleshootingChart 2ReplacingtheBattery 3ObtainingService StoringtheUPS StorageConditions2ExtendedStorage 0RunTimeVersusLoad 10.2TransferCharacteristics Specifications10.3OutputCharacteristics 10.4BatteryandchargerSurge and noise suppression 10.6OperatingenvironmentandphysicaldimensionsDeclaration of Conformity LimitedWarranty Page Serial number