Connecting MasterSwitch VM

Caution	MasterSwitch VM does not provide power protection.
	Therefore, APC does not recommend plugging the unit directly
	into any unprotected power source, such as a wall outlet.
Setting up a	1. Connect the power cord of each device you wish to connect
single unit	to the outlets on the front of the unit.

2.Connect the 10Base-T network port located on the rear panel of the controller to the network, using an appropriate cable.

3.Connect the RJ-11 port labeled To PDU on the controller front panel to the RJ-11 port labeled In on the unit, using the provided communication cable (APC part number 607- 0035A).

4.Plug the unit into a protected power source.

Continued on next page