American Power Conversion AP9221EXPX166 Over the Network by ARP. Address Resolution Protocol To

Page 17

Quick Configuration continued

Configuring

Over the Network by ARP. (Address Resolution Protocol) To

TCP/IP settings,

configure MasterSwitch VM TCP/IP settings using ARP:

continued

1.Connect the unit to the network.

2.From a command prompt on a computer connected to the local subnet, type arp -sip_addr_card mac_card. See the example below:

arp -s 159.215.240.22 00-c0-b7-78-ad-

90

Note: The MAC address can be found on the Quality Assurance slip, on the TCP/IP menu from the Control Console, and on a sticker on the bottom of the unit.

3.Type telnet ip_addr. See the example below:

telnet 159.215.240.22

The default user name and password are both apc. Configure the correct Subnet Mask and default Gateway in the TCP/IP section of the Network menu.

Continued on next page

13

Page 16 Page 18
Image 17
Page 16 Page 18
Contents MasterSwitch VM Additional Documentation Thank YouContents Page Preliminary Information Part Number Quantity Installing MasterSwitch VM Mounting in a NetShelter enclosure Mounting in a NetShelter enclosure Mounting the controller Installing MasterSwitch VM Hardwiring procedure Connecting MasterSwitch VM For the first unit in your configuration Quick Configuration On next Configuring TCP/IP settings Over the Network by ARP. Address Resolution Protocol To Through a Web browser Page APC Worldwide Customer Support
Top Page Image Contents