4.Use the handles Πon the side of the UPS to sup- port the unit.
|
| Due to the weight of the UPS, two people are re- |
|
| quired to install it in the rack. |
|
| 5. In |
Œ | • | cleat • that must slide into the groove on the rails. |
|
| Slide the UPS into position. |
6. Use the four ornamental screws supplied with the UPS to attach the mounting brackets to the rack post in both two and four post mounting.
Check the rack to make sure it will not tip after loading the UPS into the rack.
Reinstalling the Battery | If you removed the battery before mounting the UPS in |
| the rack, follow this step to reinstall it. |
| Supporting the battery on the bottom, align it with the |
| battery door opening and slide it into the compartment. |
CONNECTING THE BATTERY AND ATTACHING THE FRONT BEZEL
Œ
0
The battery is accessible from the front of the UPS. This procedure requires a Phillips head screwdriver.
1.Use a screwdriver to remove the two battery door screws and open the door.
2.Locate the battery cables tucked on top of the bat- tery.
3.Locate the UPS battery connector jack Πto the right of the battery tray.
4.To connect the battery cable plug to the battery jack, push the plug into the jack so the metal pieces inside each part are touching. Press firmly to ensure a tight connection. You will hear a “snap” when the connector is seated properly.
5.Tuck the white cord and the battery cables into the space above the UPS battery.
6.Close the battery door and replace the screws.
6 |