American Power Conversion SU24R2XLBP specification

Removing the Battery

•Œ

Mounting the UPS in a Rack

The battery is accessible from the front of the UPS. This procedure requires a Phillips head screwdriver.

1.Use a screwdriver to remove the two battery door screws and open the door (hinged panel).

2.The battery is disconnected for shipment.

3.To disconnect the battery, take out the white cord that is tucked into the space above the battery Œ. This cord serves as a handle for the connector plug.

4.Be careful during this step—the battery is heavy.

Pull the battery out of the UPS by pulling the clear la- bel •, not the white cord. (The battery consists of a string of four batteries. The white cord is connected to the battery leads, not the body of the battery.)

1.Install the mounting rails in the rack (required for four-post racks only). Directions are included with the rail kit.

2.For a four-post rack, attach a mounting cleat to each side of the UPS.

3.Attach the mounting brackets to the UPS before mounting the UPS in your rack, (below). Each mount- ing bracket attaches to the UPS with four screws (in- cluded). Two sets of bracket holes are located on the sides of the UPS.

If you are using a four-post rack, attach the mounting brackets in the forward position. For two post rack mounting attach the brackets at the mid-point posi- tion.

Four-Post Rack	Two-Post Rack
Bracket Position	Bracket Position

5	990-1048, Revision 1 12/00