American Power Conversion SU24R2XLBP installation manual Stacking the UPS on a Battery Pack

Page 6

STACKING THE UPS ON A BATTERY PACK

Note: For rack mounting, proceed to Mounting the UPS in a Rack, below.

Ba t t e r y P a c k

0

1.Unpack the four mounting feet shipped in the mounting kit.

2.Turn the UPS on its side so the bottom surface is accessible.

3.Locate the indentations on the bottom of the UPS that mark the feet positions (indicated by arrows in the figure at left).

4.Peel away the protective film on the back of one foot, align the adhesive side with an indentation on the UPS, and press hard to affix the foot to the UPS. Repeat this step for all feet.

5.Turn the UPS right side up and place it either on the floor on an optional battery pack (shown). The battery pack cover has indentations to accommodate the feet on the bottom of either a UPS or another battery pack.

Do not step on the UPS. The UPS chassis is not designed to support additional weight.

6.Continue with Connecting the Battery and Attaching the Front Bezel, to complete the installation.

MOUNTING THE UPS IN A RACK

The UPS comes with standard 19-inch (46.5 cm) rack mounting rails, brackets, and cleats. The rack can have any of the common types of equipment mounting holes (square, round-threaded, or round- non-threaded). All necessary hardware is provided.

The UPS is heavy. To lighten it, you may remove the battery before mounting the unit in the rack. If you do not want to remove the battery, continue with Mounting the UPS in a Rack (next page).

990-1048, Revision 1 12/00

4

Image 6
Contents APC Smart-UPS Page Safety Information Deenergizing Safety Installation Dle the weightStacking the UPS on a Battery Pack Removing the Battery Mounting the UPS in a Rack If you removed the battery before mounting the UPS 990-1048, Revision 1 12/00 Accessories Transporting Your SMART-UPS Removing the UPS from the Rack Troubleshooting TionService CONTACT, REGULATORY, and Warranty Information Limited Warranty