Electrical Specifications

Introduction

Attention:

•Operation above the input voltage range may cause equipment damage.

•Operation below the input voltage range may cause overload or automatic shutdown. When connecting directly to a branch circuit, check that the line voltage is within specifications. When connecting to the UPS, check that the line voltage into the UPS is within specifications before transferring to bypass mode.

Note: In order for AP9626 models to output the full 5000 VA, the input must be hardwired to a 5500 VA source.

Installation	With Line Cord		With Hardwire
	(AP9826 or AP9627)		(AP9626 or AP9628)
Nominal Input Voltage		208 Vac
Nominal Output Voltage		120 Vac
Input Voltage Range		185-230 Vac*
Input Current Rating	24 A		26 A
Line Frequency		60 Hz
Efficiency		90-95%
Maximum Input Power	5000 VA		5500 VA
Maximum Output Power	4500 VA		5000 VA

*For continuous operation below Vin = 205 Vac, the output load must be reduced to limit the maximum input current to the amount specified above. Continuous operation above the maximum specified input current may cause the unit to overheat and shut down. Please contact APC for additional information.

**Not available for AP9627.

Model	AP9626	AP9627		AP9628
Input Power	3 ft cord with L6-30P or	2 ft cord with L6-30P		Hardwire
Distribution	hardwired
Output Power	(2) 15 A circuits with	(4)	20 A circuits with	Hardwire
Distribution	(4) 5-20R and (2) 15 A circuits	(4)	L5-20R
	with (2)5-20R

4	APC Step-Down Transformer User Manual