PROBLEM AND/OR POSSIBLE | SOLUTION | |
CAUSE |
| |
BATTERY CHARGE AND LOAD LED BARGRAPHS FLASH SIMULTANEOUSLY | ||
The UPS has shutdown. The | Check that the room temperature is within the specified limits for operation. | |
internal temperature of the | Check that the UPS is properly installed, allowing for adequate ventilation | |
UPS has exceeded the allow- | ||
(see Position the UPS). | ||
able threshold for safe opera- | ||
| ||
tion. | Allow the UPS to cool down. Restart the UPS. If the problem continues, | |
| contact APC (see Contact Information). | |
|
| |
DIAGNOSTIC UTILITY VOLTAGE | ||
All five LEDs are illuminated. | The line voltage is extremely high and should be checked by an electrician. | |
|
| |
There is no LED illumination. | If the UPS is plugged into a properly functioning utility power outlet, the | |
| line voltage is extremely low. | |
|
| |
ONLINE LED |
| |
There is no illumination. | The UPS is running on battery, or it must be turned on. | |
|
| |
The LED is blinking. | The UPS is running an internal | |
|
| |
Service
If the UPS requires service do not return it to the dealer. Follow these steps:
1.Review the problems discussed in Troubleshooting to eliminate common problems.
2.If the problem persists, contact APC Customer Service through the APC web site, www.apc.com/support.
Note the model number of the UPS, the serial number, and the date purchased. If you call APC Cus- tomer Service, a technician will ask you to describe the problem and attempt to solve it over the phone. If this is not possible, the technician will issue a Returned Material Authorization Number (RMA#).
If the UPS is under warranty, repairs are free.
3.Pack the UPS in its original packaging. If this is not available, refer to www.apc.com/support for informa- tion about obtaining a new set.
Pack the UPS properly to avoid damage in transit. Never use Styrofoam beads for packaging. Damage sustained in transit is not covered under warranty.
Always DISCONNECT THE BATTERY before shipping in compliance with U.S. Department of Transportation (DOT) regulations. The battery module(s) may remain in the UPS; it does not have to be removed.
4.Mark the RMA# on the outside of the package.
5.Return the UPS by insured, prepaid carrier to the address given to you by Customer Service.
Contact Information
U.S. Customers - Refer to www.apc.com/support.
International Customers - Refer to www.apc.com, select the appropriate country from the country selection field, and select the Support tab at the top of the web page.
10