Wiring
Install an approved 20 A
Ensure the utility circuit breaker is OFF.
•Unlock and open the front/top panel on the CTSLLP/G. Refer to the diagram below for wiring details.
•Connect the black and white wires from the incoming utility line.
•Route the power feed coax to the bottom of the enclosure and attach to the coax cable adapter using a pin connector.
•Attach the stinger lug to the pin connector center pin.
•Attach suitable solid copper ground wire to the enclosure ground lug and ground in accordance with local codes.
•Check for voltages between each connector pin and ground using a multimeter. Presence of voltage indicates an improper ground. If voltage is present ensure the ground contact is secure.
•Reinstall the front/top panel on the CTSLLP/G.
7