APC SMC1500, SMC1000 operation manual Feature Reference Guide, System Faults, Seconds Status

System Faults

1000/1500 120 Vac	1000/1500 230 Vac	P00	Output Overload
		P01	Output Short Circuit
		P02	Output Over Voltage
		P04	Unit Over Temperature
su0752a	su0752b	P06	AVR Relay Fault
		P13	Inverter Fault

Note: Refer to the "Feature Reference Guide" on page 8 for a detailed description of the front panel buttons and icons.

For more information on System Faults, contact customer support at the APC Web site, www.apc.com/support.

Feature Reference Guide

Function	Button	Timing	UPS	Description
		(seconds)	Status
Power
Power On		0.2	Off	Press the POWER ON/OFF button to turn on the UPS. The UPS will operate
				on AC power.
				If AC power is not available the UPS will operate on battery power.
Power Off		2	On	Press the POWER ON/OFF button to turn off the UPS.
Display
Status Inquiry		0.2	On	Press to verify the status or condition of the UPS. The LCD will illuminate
				for 60 seconds.
Power Saving		2	On	The LCD will illuminate and the UPS will beep to confirm Continuous
mode				Illumination mode is activated.
				The LCD will extinguish and the UPS will beep to confirm that
Continuous
				Power Saving mode is activated. While in Power Saving mode, the LCD
Illumination
				will illuminate if a button is pressed or an event occurs, then extinguish after
				60 seconds of no activity.
Mute
Event Specific		0.2	On	Disable any audible alarms caused by an event.
Enable/Disable		2	On	Enable or disable the audible alarms. The Mute icon will illuminate and the
				UPS will beep once. The Mute feature will not activate unless the UPS is
				operating on battery power.
Sensitivity		6	Off	The Load Capacity icon will flash to indicate the UPS is in Program mode.
				Use the POWER ON/OFF button to scroll through and select Low, Medium,
				and High sensitivity levels. The UPS will beep to confirm the selection.
				Refer to Sensitivity adjustment settings on page 4 in this manual.
Self-Test		2	On	The UPS will automatically run a self-test of the internal battery when the
				UPS is turned on.
				A manual self-test can be run at any time while the UPS is operating.
				Press and hold the MUTE button, then press the DISPLAY button for 2
				seconds until the system emits a short beep to indicate the UPS has started a
				Self-Test.
Event Reset		0.2	On	When the Event screen is visible, press and hold the DISPLAY button, then
				press the POWER ON/OFF button to clear the AC failure event counter.
Fault Reset		2	Fault	After a fault has been identified, press the POWER ON/OFF button to remove
				the visual indication and return to standby status.

8 Smart-UPS C 1000/1500 VA 120/230 Vac Tower