Installing the Mounting Rails in the Rack

5.Connect the battery and attach the front bezel.

6.Connect the equipment and power to the UPS.

7.Turn on the UPS.

INSTALLING THE MOUNTING RAILS IN THE RACK

Install the mounting rails in the rack. Directions are included with the rail kit. The UPS comes with standard 19-inch (46.5 cm) rack mounting rails, brackets, and cleats. The rack can have any of the common types of equipment mounting holes (square, round-threaded, or round-non-threaded). All necessary hardware is provided.

REMOVING THE BATTERY MODULE

The UPS is heavy. To lighten it, remove the battery module before mounting the unit in the rack.

Due to its weight, two people are required to remove the battery module.

The battery module is accessible from the front of the UPS (shown at left).

This procedure requires a Phillips screwdriver.

1. If the UPS has been in operation, locate the white cord Œ attached to the battery module connector plug •. Grasp the cord and pull firmly toward you until the connector plug is disconnected.

		•	DO NOT pull the battery module cables.
			DO NOT pull the battery module cables.
	Œ		If the UPS has not been in operation, the battery
	Œ		will not yet be connected. The UPS ships with
			will not yet be connected. The UPS ships with
			the battery disconnected.
Ž			2. Use a screwdriver to remove the two battery
Ž			module mount screws located at the top corners
			module mount screws located at the top corners
			of the face plate Ž.
			Set the screws aside in a safe place. You will re-
			place them later.
			Ž