Oad Va | APC 2200VA, 3000VA instruction

ON-BATTERY OPERATION

The Smart-UPS switches to battery operation automatically if the utility power fails. While running on-battery, an internal alarm sounds (periodic beeps).

Press the button (front panel) to silence the UPS alarm (for the current alarm only). You can change the audible indicator if you are using the PowerChute software.

If the utility power does not return, the UPS continues to supply power to the connected equipment until exhausted. The UPS will begin to beep continuously approximately two minutes before the UPS final low battery shutdown. If using a computer, you must manually save your files and power down before the UPS turns off, unless you are using PowerChute interface software that provides auto- matic, unattended shutdown.

DETERMINING ON-BATTERY RUN TIME

UPS battery life differs based on usage and environment. It is recommended that the battery/batteries are changed once every three years.

Although the following run times are “typical,” these numbers are subject to change. For the most recent and accurate sizing information, please consult the Size-UPS section of APC’s website at www.apc.com/sizing.

LOAD (VA)	LOAD (WATTS)	RUN TIME (MINUTES)
750	600	40m

1125	900	25m

1500	1200	16m

2200	1750	11m

2500*	2000*	9m
3000*	2400*	7m

*Runtimes at these load levels are applicable to the SU3000RMXL3U only.

For non-power factor corrected loads, the power in watts may be limited by the maxi- mum VA rating.

LOAD (VA)