ADTRAN 1203019L3, 1203019L2, 203019L1 user manual Power Supply Connection

Page 23

NT1 ACE User Manual

powered from the NT1, verify that the total power require- ment of the connected TE is less than 8.9 watts.

To connect the NT1 ACE to the NT1 Power Supply, perform the following steps as illustrated in Figure 4.

1.Connect the Power Supply to the NT1 ACE at the POWER jack located on the NT1 ACE.

2.Plug the Power Supply into the nearest wall outlet supplying 110 VAC, 60 HZ.

3.On the NT1 ACE, verify that the POWER and ERROR indicators are illuminated. After approximately 15 seconds, the READY indicator should flash at a 1 Hz rate. Should any of the indicators fail to operate as stated, see the section Troubleshooting on page 11.

POWERNETWORK LOCAL

1 0 0 - 1 2 0

VA C

ADTRAN ISDN PS2

READY

ERROR

POWER

Figure 4. Power Supply Connection

61203019L1-1

NT1 ACE User Manual

7

Image 23

Contents NT1 ACE FCC ID HDC1203019L1 61203019L1-1 Iii Isdn Adtran Year 2000 Y2K Readiness Disclosure Canadian Emissions Requirements Vii Viii 61203019L1-1 Affidavit Requirements for Connection To Digital Services 61203019L1-1 61203019L1-1 Xii 61203019L1-1 Important Safety Instructions Xiv 61203019L1-1 Table of Contents Figures Adtran NT1 ACE Unit OverviewStatus Indicators LED IndicatorsInspection Passive Bus DescriptionRepair and Return MaintenanceRemote Testing Setting the Option SwitchesPin Description Network Connector Pin AssignmentsLocal Bus Connector Pin Assignments Powering TEs from the NT1 ACEPowering with the NT1 Power Supply Power Supply Connection Connecting the Terminal Equipment Short Passive Bus Configuration Short Passive Bus ConfigurationExtended Passive Bus Configuration Extended Passive Bus ConfigurationPower indicator does not illuminate TroubleshootingCustomer Interface S/T SpecificationsNetwork Interface U Network Compatibility Faceplate IndicatorsPower Power Supply Specifications61203019L1-1 Technical Support and Warranty Information