Anton/Bauer HyTron 100, HyTRON 140, HyTRON 50 specs

CHARGING WITH LOGIC SERIES

INTERACTIVE CHARGERS

Charge this battery fully before using. Allow the battery to reach a steady green (LifeSaver→) mode before using. Charging is automatic on all Logic Series InterActive chargers. The flashing red and green lights indicate the charger and battery are establishing communications. The following are the standard indications on any Logic Series InterActive Charger (Please refer to the Charger manual for complete charging instructions):

•Alternating red and green: Evaluating battery and/or rejuvenating low voltage battery.

•Steady red: Battery waiting to charge (may either be in line to charge or holding for temperature stabilization).

•Flashing red: Charging.

•Flashing green: Balancing mode or Ready/Verifying. Battery is typically more the 80% charged.

•Steady green: LifeSaver mode. Batteries will remain 100% ready for use indefinitely.

The battery should remain on the charger until just prior to being used. The patented LifeSaver maintenance routine keeps the battery 100% charged and balanced by eliminating the typical self-discharge that can cripple a battery that is stored for any length of time on the shelf. Do not remove the HyTRON batteries from the charger more than 8 hours prior to actual use. For best results, this battery should be returned to the Logic Series InterActive charger within 48 hours of being used. Please read the individual charger Owner’s Manual to become acquainted with the many unique features of the chargers.