COREBUILDER® 5000 SWITCHMODULE QUICK START AND REFERENCE | 5 |
cThe total watts that are available in the hub (from step a) must be greater than the total watts that are required by the SwitchModules (from step b). Use the following worksheet to calculate power consumption:
Voltage | Watts |
| Watts | Watts | |
Available |
| Required by | |||
Category | – | = Remaining | |||
in Hub | SwitchModule | ||||
+5 |
| – |
| = | |
| – |
| = | ||
+12 |
| – |
| = |
2To expose slots for SwitchModule installation, remove as many blank faceplates from the chassis as required.
WARNING: Hazardous energy levels exist inside of the hub. Do not place hands or objects into the hub or touch components on an inserted module.
3Insert each SwitchModule into the module guides at the top and bottom of the selected slot and slide it into the chassis by pressing firmly at the top and bottom of the front panel (see the figure at right).
4Lock the SwitchModules into place by applying pressure to the front panel with one hand while you close each ejector handle. Ensure that the SwitchModule remains fully seated in the backplane connector while you close the ejector handles.
5To secure the SwitchModule front panel to the front of the chassis, use a
3 to 5 inch pounds. Do not overtighten.
WARNING: For safety reasons and to ensure adequate cooling airflow, install blank faceplates over all empty slots.
Slide the SwitchModule into the selected slot as shown here.
6To ensure that the DMM recognizes the installed SwitchModule, enter the SHOW MODULE ALL command. Verify that the model number of the SwitchModule appears in the correct slot.
There may be a delay (no more than 30 seconds) before the DMM recognizes the SwitchModule.
7Ensure that the hub is operating with enough power by entering the SHOW POWER BUDGET command.