12. THREADING FILM
only
| 12.1. Decaling |
|
1. | Turn the power switch on (“I” position). The Power | |
| switch is located on the rear left side of the unit. | |
2. Complete the steps as in the “LOADING FILM” | ||
| section (see page 10). | |
3. | Set the top roller to the desired temperature (RSC- | |
| 1650H and | |
4. | Take off the | |
RSC Series
9.Cut and separate the release liner and the film.
(Figure 3)
Figure 3
10.Thread the craft paper behind the Lower Idle Bar to the top film that is resting on the main roller (do not use the Lower Idle Bar for Mounting). (Figure 4)
11.Reinstall the Feed Table and the
Guide,and close the Safety Cover. | Figure 4 |
12.Adjust the nip setting to appropriate gap.
13.Insert and push the leader board until they reach the front nip point.
14.Push the Run button.
5. Pull the top film down over the Safety Cover to the |
bottom of the craft paper / Mounting film. | Figure 1 |
15. Push the leader board into the rollers. (Figure 5)
Figure 5
6.Align and center the craft paper / Mounting film to the top film and tighten the two lower core screws (Figure 1).
7.Thread the top film underneath the Upper Idle Bar.(Figure 2)
8.Tape the top film on to the Release Liner Take-
Up.(Figure 2) | Figure 2 |
11
16. Adjust the top and bottom tension knob by rotating it clockwise or counterclockwise. Turn it until the top and bottom roll films have some resistance varies
(the tension depending on the film thickness; the |
|
thicker the film the more tension is required). |
|
(Figure 6) | Figure 6 |
|
12