7. SPEED AND TEMPERATURE SETTINGS
|
|
|
| |||
Speed# | Speed(Ft/min,M/min) |
| Temp.# | Temperature( F, | C ) | Temperature( F, C) |
1 | 4(1.2) |
| 1 | No Heating |
| No Heating |
2 | 6(1.7) |
| 2 | No Heating |
| 86(30) |
3 | 7(2.2) |
| 3 | 91(33) |
| 113(45) |
4 | 9(2.6) |
| 4 | 97(36) |
| 140(60) |
5 | 10(3.1) |
| 5 | 104(40) |
| 230(110) |
6 | 12(3.6) |
| 6 | 111(44) |
| 239(115) |
7 | 14(4.2) |
| 7 | 115(46) |
| 248(120) |
8 | 15(4.5) |
| 8 | 117(47) |
| 257(125) |
9 | 16(5.0) |
| 9 | 124(51) |
| 266(130) |
|
|
|
|
|
|
|
8. ROLLER NIP SETTING
It is important to adjust the roller nip settings to the appropriate thickness of the board being used. Use the guide below to adjust to the correct position.
NO. | Inches | Metric | |
(mm) | |||
|
| ||
|
|
| |
1 | Lamination | Lamination | |
|
|
| |
2 | 1/ 25" | 1 | |
|
|
| |
3 | 3/16"~1/4" | ||
|
|
| |
4 | 3/ 8"~1/2" | ||
|
|
| |
5 | 3/5" | 15 | |
|
|
|
NOTE: If you don't want to laminate,please place the pressure lever to the "Open position(NO.5)".
RSC Series
9. USING FOOT PEDAL AND REMOTE CONTROL
USING FOOT PEDAL
Place the foot pedal on the floor in front of the machine. Once all correct settings are displayed, you may use the foot pedal to operate the laminator for “Hands Free Operation.” To activate the machine, press the foot pedal once and then release. Repeat to stop the rollers.
USING REMOTE CONTROL
1 2 3
Located on the rear left side of the laminator.
1. PRESS RUN – To activate the rollers.
2. PRESS STOP – To stop the rollers from turning.
3.PRESS REV – To reverse the rollers. Press and hold the button (useful for jams or misted media).
7 | 8 |