12. THREADING FILM
only
RSC Series
9.Cut and separate the release liner and the film. (Figure 3)
Figure 3
10. Thread the craft paper behind the Lower Idle Bar to the top film that is resting on the main roller (do not use the Lower Idle Bar for Mounting). (Figure 4)
12.1. Decaling |
1. Turn the power switch on (“I” position). The Power |
switch is located on the rear left side of the unit. |
11. Reinstall the Feed Table and the
Figure 4
2. Complete the steps as in the “LOADING FILM” | |
| section (see page 10). |
3. | Set the top roller to the desired temperature (RSC- |
| 1650H and |
4. | Take off the |
5. | Pull the top film down over the Safety Cover to the |
bottom of the craft paper/mounting film. | Figure 1 |
6.Align and center the craft paper/mounting film to the top film and tighten the two lower core screws (Figure 1).
7.Thread the top film underneath the Upper Idle Bar.(Figure 2)
8.Tape the top film on to the Release Liner Take-
Up.(Figure 2) | Figure 2 |
11
12.Adjust the nip setting to appropriate gap.
13.Insert and push the leader board until they reach the front nip point.
14.Push the Run button.
15. | Push the leader board into the rollers. (Figure 5) | Figure 5 |
| ||
16. | Adjust the top and bottom tension knob by rotating | it |
| clockwise or counterclockwise. Turn it until the top | |
| and bottom roll films have some resistance (The | |
| tension varies depending on the film thickness; the | |
| thicker the film the more tension is required). | |
| (Figure 6) | Figure 6 |
17.Press the Stop button when the leader board has completely exited from the rollers.
18.Use the Cross Cutter to cut the leader board from the web (see page 9).
19.Set the nip setting to the appropriate position for the
12