Royal Sovereign RSC-1650H Installation of Front Feeder and Rear Rewinder Options, Mounting

12.2 Mounting

1.Lay the decaled image face down on a flat surface. Carefully peel back and put a crease along the edge of the release liner (Approximately 1 inch or 25mm, Figure 1).

Figure 1

2.With the image facing up, align the image onto the board. Press firmly from the center out (Figure 2).

Figure 2

3.Adjust the pressure lever to ensure the proper opening (Figure 3).

Figure 3

4.Flip the image over the upper roller and hold on to the release liner (Figure 4).

Figure 4

5.Press the foot pedal once, and then let it go while slowly pulling the release liner as the board enters the main roller nip (Figure 5).

Press the foot pedal once again when the board has completely exited from the rear of the unit.

Trim the board if necessary.

Figure 5

13

RSC Series

13.INSTALLATION OF FRONT FEEDER AND REAR REWINDER OPTIONS

NOTE: Below options are to be installed by an authorized

RS reseller.

Installation of the Front Feeder Option (Includes 2 brackets, one spindle, and mounting hardware).

1.	Install the Front Feeder to the inside of the front frames using		Figure 1
	four 1/4" (M6) hexagon bolts on each side (Figure 1).
Installing the Rear Rewinder Option (Includes motorized winder,
bracket, one spindle, and mounting hardware).
1.	Remove the left and right covers by using a screwdriver
	(four screws on each side cover) (Figure 2 & 3).	Figure 2	Figure 3

2. Remove the lever knob screw and lever (Figure 4).

Figure 4

3.Remove the rear cover by removing all 12 screws (4 top, 4 bottom, and 2 on each side) (Figure 5 & 6).

Figure 5 Figure 6

4.Disassemble the power switch bracket and place the left rewinder outside of the frame; fasten with round head 3/16"(M5) screws (included in the option kit). Then, reinstall the power switch bracket (Figure 7).

5.Install the right rewinder on the outside of the frame and

	connect the motor wire connector to the rear wire	Figure 7
	(Figure 8 & 9).
6.	Reinstall the rear cover.
7.	Reinstall the side covers.
8.	Reinstall the lever knob and screw.
	Figure 8	Figure 9
	14