Oki 80 Plus III manual Testing the Printer

Page 13

Testing the Printer

You can test the printer to ensure that it is running properly. The sample on the following page shows what a printout of the test may look like. The test pattern varies depending on the printer model and the character set selected when the printer was ordered.

Run the test after loading the paper, but before connecting it to a host system. If the characters do not print properly, check to make sure the paper is installed correctly, and that suitable thermal paper is being used.

If the printer is still not working correctly, contact your dealer.

Test the Printer

1.Open the printer cover.

2.Plug the DC power cable from the external power supply into the printer.

3.Plug the AC power cable into the external power supply.

4.Plug the AC power cable into a grounded three-pin power socket.

6.Close the paper cover.

7.The printer will print some technical information.

8.To print some sample code pages, press the line feed button.

These modes are described in the OKIPOS 80 Plus III Programmer’s Guide .

To order this book, please contact your dealer. If you have accidentally entered this menu mode, disconnect AC power and then reconnect it again.

English

5.The status LED will start flashing after approximately 1 ½ seconds.

User’s Guide

13

80p3gb.p65

13

12/01/99, 11:43

Image 13
Contents User’s Guide Okipos 80 Plus English ContentsSafety Instructions About the Okipos 80 Plus III Printer What Is in This Book?Text 8LPI 42LPS Description of the Okipos 80 Plus III Printer15.6 CPI Unpacking the Printer Setting Up the PrinterCheck That All Items Are Present Choosing a Location for the Printer Connecting the Power Cable Loading and Removing Paper Testing the Printer Connect the Serial Cable Connecting the CablesSetup Checklist Operating the Printer Cleaning the PrinterOperating the Keypad Cleaning the Thermal Printhead Cash Drawer Pin Assignments AppendixSerial Cable Parallel Cable Pin Signal Description DirectionIndex