Epson TM-T88II user manual DIP Switch and Paper Near End Settings A-5

Page 47

Notes:

Changes in DIP switch settings (excluding switch 2-8 interface reset signal) are recognized only when printer power is turned on or when the printer is reset using the interface. If the DIP switch setting is changed after printer power is turned on, the change does not take effect until the printer is turned on again or is reset.

If you turn on DIP switch 2-8 while the printer is turned on, the printer may be reset, depending on the signal state. Do not change DIP switches while the printer power is on.

If the print density is set to level 3 or 4, the printing will be at low speed.

In a low power consumption, printing is fixed to 70 mm/sec.

DIP Switch and Paper Near End Settings A-5

Image 47
Contents TM-T88II Series Labels Printer Parts and LabelsQuick Reference Setting Up the PrinterInstalling and Replacing Paper Solving ProblemsPage Iii EMC and Safety Standards AppliedProduct Name TM-T88II Model Name M129B For American Users CE MarkingFCC Compliance Statement Gereäuschpegel Reference Setting Up and UsingAbout This Manual Application Software FeaturesIntroduction PrintingViii Introduction Options and AccessoriesSpecified Thermal Roll Paper NTP080-80 Ordering Paper and SuppliesKanzaki Specialty Papers, Inc Other Qualified Suppliers for Thermal PaperJujo Thermal Oy Finland Contents Xii Appendix a DIP Switch and Paper Near End SettingsUnpacking Setting Up the PrinterSetting Up the Printer 2Setting Up the Printer Connecting the Cables and Grounding the PrinterConnecting the computer Connecting the Drawer Anschließen der Schublade 4Setting Up the PrinterGrounding the Printer Connecting the Power SupplyPage Installing or Replacing the Paper Roll 8Setting Up the Printer Tear off the paper as shown Running the self test Using the Power Switch Cover10Setting Up the Printer Self TestSelf test printing Please press the Paper Feed button 12Setting Up the Printer Adjustments and SettingsControl Panel Using the PrinterUsing the Printer Operating the Control PanelPanel lights 2Using the PrinterPrinting problems TroubleshootingTroubleshooting General problemsPrinting is poor Error light is off, but nothing is printed2Troubleshooting Paper is jammed inside the printer Cleaning the print headPaper handling problems 4Troubleshooting Auto cutter is jammed Auto cutter problems6Troubleshooting Abcdefgh Hexadecimal Dump8Troubleshooting Reference Information Printing SpecificationsReference Information 2Reference Information Line spacing default 4.23 mm 1/6Paper roll single-ply Size Paper SpecificationsConsumption at Electrical CharacteristicsCurrent Life TemperatureReliability Environmental Conditions6Reference Information Serial interface specifications DIP Switch and Paper Near End SettingsSetting the DIP Switches DIP switch functions2DIP Switch and Paper Near End Settings Print Density Selection DIP Switch and Paper Near End Settings A-34DIP Switch and Paper Near End Settings Parallel interface specificationsDIP Switch and Paper Near End Settings A-5 6DIP Switch and Paper Near End Settings Changing the DIP switch settingsDIP Switch and Paper Near End Settings A-7 Adjusting the Paper Near End Detector8DIP Switch and Paper Near End Settings Page 1999.12