4
Notes
Need
Photo 14
Photo 17
Photo 18
Photo 19
Photo 20
WX Technical Instructions
Step 14
Install the retaining ring.
(See Photo 14)
Step 15
Set waste hopper aside and cover.
Step 16
If you have a toner hopper fixture, place toner hopper in fixture or place toner hopper on the workbench.
Step 17
Remove the two screws holding the end cap on the gear side of the toner hopper.
(See Photo 17)
Step 18
Before removing the end cap, lift the bias strip off its positioning post next to the doctor blade.
(See Photo 18)
Step 19
Slide the end cap off. Note the position of the white gears, then remove the four largest ones and set them aside.
(See Photo 19)
Step 20
Turn the cartridge around. Remove the two screws that hold the other end cap on and remove.
(See Photo 20)