8
Notes
Photo 33
Photo 34
Photo 35
Photo 36
Photo 37
WX Technical Instructions
Step 33
Remove fill plug and fill with toner.
(See Photo 33)
Step 34
Use compressed air or a vacuum and clean the toner hopper seal channel end foam on the back of the mag roller sec- tion. Wipe off the back of the mag roller section.
(See Photo 34)
NOTE: If these foam pads are damaged, they need to be replaced.
Step 35
These foam strips stop the cartridge from leaking after it has been split. The foam strips are applied right across the seal channel end foam.
(See Photo 35)
Step 36
Fold the seal back across the toner hop- per. Now
(See Photo 36)
NOTE: The posts on the mag roller section needs to fit back into the holes on the toner hopper section.
Step 37
Using the toner hopper clips, clip the two sections together.
(See Photo 37)