Various Printing Operations
∙ If insufficient pressure is applied to the image, bubbles can form when the film is lifted off. Make sure to apply enough pressure, particularly around the edges and corners.
∙ Set the iron for 160°C/320°F (cotton). If the iron has outlet holes for steam, set the iron to Dry and avoid the holes, using a flat part of the iron.
3. Lift off the finishing sheet after the paper and the film have cooled completely.
Note
If the paper and film have not cooled completely, the film will not come off smoothly.
4.Starting with the corners, peel off the film, making sure that the film comes off smoothly.
Step 6¨ Curl Correction
When you transfer an image on a thin sheet of paper, the sheet may still be curled up after peeling off the back print film. In this case, correct the curl with the following procedure.
1.Place a sheet of plain paper (paper for copiers) on top of the transferred image on the curled sheet.
Plain paper
(paper for copiers)
Curled sheet with a trans- ferred image facing up
2.Roll up both sheets together with an approximate diam- eter of 1 inch to resist the curl.
Plain paper
(paper for copiers)
Curled sheet with a transferred image facing up
Approximate diameter of 1 in / 25 mm
79